3
En
English
Note: Pioneer refuses any responsibility for damage
or accidents resulting from improper installation.
• Each speaker weighs 3.7 kg. Select a location for
installation with stable surface, providing sufficient
distance between the speaker system and nearby walls
as shown in the accompanying illustration.
The emphasis produced by the bass speakers (woofers)
can be adjusted to some degree by varying the distance
between the speaker system and the wall behind it.
Adjust the distance between speakers and side walls to
eliminate any subject difference between right and left
speakers.
• The most natural stereo experience will be produced
when right and left speakers are equidistant from the
listening position. Speaker cables should also be the
same lengths for right and left speakers.
• When placed beside a television set, right and left
speakers should be installed so far as possible in the
same plane as the television screen.
• In order to produce optimum breadth of sound when
used in conjunction with a television, install the
television in the center between the two speakers, and
set the speakers at distances from the television such
that the angle between the speakers and listener is
about 50° to 60°.
• In rooms with hard surfaced floors and walls, sound
may be reflected off the floor and walls, creating echoes
or harmonics. In such cases, it is recommended to
adjust the sound characteristics through the use of wall
hangings, curtains, or drapes, or by placing a carpet on
the floor. Placing curtains all the way to the corners of a
room may help prevent speakers from producing
muffled sound. Likewise, if the wall opposite the
speakers (behind the listening position) is a hard wall,
placing a thick curtain on the wall may produce good
results by helping prevent the generation of standing
waves.
Applying non skid pads
The use of non skid pads is recommended depending on the
installation location. Apply the pads to the four corners of the
side of the speaker which will be on the bottom. Note that
depending on the location, the pads may not provide fully
sufficient traction to prevent slipping, so care should be
taken not to install the speakers in conditions where they
may be prone to slide.
Installing and removing the grille net
The front panel grille net may be removed if desired. The
following instructions are provided for removal and
replacement of the grille net:
1
Holding the lower edge of the grill net with both
hands, pull gently forward, away from the speaker.
The lower side of the grille net will detach from the speaker
body.
2
Pull the top side of the grille net away from the
speaker.
The grille net will detach from the speaker body.
3
To replace the grille net on the speaker, align the
holes on the corners of the grille net with the pegs on
the four corners of the speaker and press in slowly.
Connecting to an amplifier
This speaker system features banana-plug connections.
1
Turn off the power at the amplifier.
2
Connect each supplied speaker cable to one set of
the amplifier’s speaker output terminals and the speaker
system’s input terminals.
The red terminal is the positive
, and the black terminal is
negative
. Connect the wire with the white line to the
terminal, and the wire without the white line to the
terminal.
1
Trim a small bit of insulation from the tip of the cable,
exposing the wire cores; twist the cores before inserting into
the terminal.
Non skid pads
50 cm
20 cm
50° to 60°
Содержание S-A4SPT-PM
Страница 1: ......
