Pioneer RS-A99, Руководство пользователя

Страница: 8 / 16

9
Speaker output terminals
Please see the following section for speaker
connection instructions. Refer to
Connecting
the speaker output terminals on page 12.
a
Fuse (25 A)
b
System remote control wire (sold separately)
Connect male terminal of this wire to the sys-
tem remote control terminal of the car stereo.
The female terminal can be connected to the
auto-antenna relay control terminal. If the car
stereo lacks a system remote control terminal,
connect the male terminal to the power term-
inal via the ignition switch.
c
Fuse (40 A) × 2
d
Grommet
e
Left side
f
Right side
Note
INPUT SELECT (input select) switch must be set.
For details, see Setting the Unit on page 5.
Before connecting the
amplifier
WARNING
!
Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap sections
in contact with metal parts in adhesive tape.
!
Never cut the insulation of the power supply
to feed power to other equipment. Current ca-
pacity of the wire is limited.
CAUTION
!
Never shorten any wires, the protection circuit
may malfunction.
!
Never wire the speaker negative cable directly-
to ground.
!
Never band together multiple speaker
’
snega-
tive cables.
!
If the system remote control wire of the ampli-
fier is connected to the power terminal via the
ignition switch (12 V DC), the amplifier will re-
main on with the ignition whether the car
stereo is on or off, which may exhaust battery
if the engine is at rest or idling.
!
Install and route the separately sold battery
wire as far as possible from the speaker wires.
Install and route the separately sold battery
wire, ground wire, speaker wires and the am-
plifier as far away as possible from the anten-
na, antenna cable and tuner.
About bridged mode
Speaker impedance is max. 4
W
, please carefully
check. Improper connection to the amplifier may
result in malfunction or personal injury due to
burns from overheating.
For bridged mode for a two-channel amplifier,
with a 4
W
load, either wire two 8
W
speakers in
parallel, Left
+
and Right
*
(Diagram A) or use a
single 4
W
speaker. For other amplifiers, please
follow the speaker output connection diagram for
bridging shown on rear: two 8
W
speakers in par-
allel for a 4
W
load or a single 4
W
speaker per
channel.
For any further enquiries, contact your local
authorized Pioneer dealer or customer service.
En
8
Section
03
Connecting the units