Quick Start Installation Instructions
Page 4
4. S
ECURE THE
D
ISPLAY TO A
B
ASE AND
/
OR A
W
ALL
Follow the instructions listed below to secure the Display to a wall:
1) Remove the Securing hole-plugs from the upper
corners of the Display
2) Affix a support bolt and cable to either securing
hole on the Display
(contact your Pioneer Representative for purchase
information)
3) Fasten the end of the cable to a pillar or a wall
(some walls may require hooks sunk into an internal support
structure)
4) Repeat the process for the opposite side if needed
for additional support
Follow the instructions listed below to secure the Display to a base:
1) Position the Display on a base
(at least 1 person should support the Display at all times)
2) Place screws through the stand to the base*
(
Set all screws in place before tightening the Display to the base
)
3) Hold the Display while tightening the screws
(do not over-torque the base screws)
* Clamps may be substituted to avoid drilling screw holes for the Display stand.
Stand with screws
Stand with clamp
