Installation
Removing the control unit (Fig. 8)
Fig. 8
Insert the release plate that comes with the
unit as shown in the illustration.
Pull it towards you.
Installing the Control Unit
Installation using the flush mounting bracket (Fig. 7)
Fig. 7
Screws
Fit the flush mounting bracket into
the opening in the dashboard, raise
the claws of the bracket with a flat-
bladed screwdriver, and secure the
bracket in place.
Dashboard
124 – 126 mm
4
4–4
6m
m
Open the installation hole.
Holder
Flush mounting bracket
Fasten the control unit with velcro tape (Fig. 9)
Fig. 9
Note:
• Thoroughly wipe off the surface before affixing the velcro tape.
• Obviously, it is very dangerous if the cord gets tangled in the steering wheel, so install the cord so
that it cannot get in the way.
Velcro tape
(Rough surface)
Velcro tape
(Soft surface)
Dashboard