Pioneer Elite PDP-S23-LR, Руководство по эксплуатации

Страница: 4 / 18

English
4
CONNECTION TO A PLASMA
DISPLAY
1
Connecting the speaker cables
1
Switch off the power of the plasma display.
2
Connect the input terminals of the speaker system and
the speaker output terminals of the plasma display with
the accessory speaker cable. Make sure the positive (
ª
)
and negative (
·
) terminals match when connecting.
1. Push the lever, insert the cable into the hole, and release
the lever.
2. For the output terminals on the plasma display, push the
lever, insert the cable into the hole, and release the lever.
To the
·
terminal
To the
ª
terminal
(Speaker input terminals of the speaker system)
·
terminal (black)
ª
terminal (red)
Input terminal of speaker
White
White with gray line
ª · · ª
R L
Output terminal of plasma
display
÷
After connection to the terminals, pull lightly on the cable
to confirm that the tips of the cable are properly con-
nected to the terminals. An imperfect connection can
cause sound interruptions and noise.
÷
When cable cores stick out and
ª
and
·
lines are short-
circuited, an excessive load will be applied to the plasma
display and the operation will stop or trouble will be
caused.
÷
When the polarity is reversed for one speaker (left or right)
at the time of connection to the plasma display, the bass
reproduction will be reduced, the sound positioning will
be lost, and a correct stereo effect will not be obtained.
2
Attach the speakers to the display.
The illustration below shows how to attach
of the right speaker. Attach the left speaker
in the same way.
1
Fix the upper screw temporarily in
advance to hang the speaker on the
display (In this case, leave a space
of about 5 mm between the head
of the screw and the display).
2
Hang the speaker on the upper screw.
3
Fix the lower screw temporarily.
4
Adjust the position of the speaker and then fix the upper
and lower screws firmly.
5
Secure the cable with the cable clip as shown, then press
the remaining speaker cable into the groove (in the lower
cover).
ì
Changing the Speaker Angle
1
Remove the upper cover.
2
After pulling up the locking lever, change
the speaker angle as desired, then push
the locking lever down again.
2
4
3
NOTE:
÷
When the display is to be
moved after speaker installa-
tion, do not hold the display by
the speakers. Hold the display
with one hand on the bottom
of the unit and the other on the
handle on the rear. Do not hold
the speakers and raise the
display. This may cause the
deformation or damage of
products.
10
°
10
°
10
°
10
°
10
°
20
°
0
°
5 mm
The display
The speakers can be
adjusted in one of
four angle positions
as desired.