Initial Settings
Adjusting initial settings
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1
Press SOURCE and hold until the unit
turns off.
2
Press MULTI-CONTROL and hold until
the initial setting menu appears in the dis-
play.
3
Turn MULTI-CONTROL to select one of
the initial settings.
Turn
MULTI-CONTROL
to switch between the
functions in the following order.
CLOCK
(clock)
—
FM STEP
(FM tuning step)
—
AM STEP
(AM tuning step)
—
WARNING
(warning tone)
—
AUX1
(auxiliary input1)
—
AUX2
(auxiliary input2)
—
VIDEO IN
(AV input
setting)
—
CAMERA
(rear view camera setting)
—
REAR SP
(rear output and subwoofer con-
troller)
—
EVERSCROLL
(ever scroll)
—
TV SIGNAL
(TV signal setting)
—
D.ATT
(digital
attenuation)
—
AUDIO RESET
(audio reset)
Use the following instructions to operate each
particular setting.
#
You can also select the function by pressing
FUNCTION
on the remote control.
#
To cancel initial settings, press
BAND
.
#
When you select
CAMERA
(rear view camera)
in
VIDEO IN
, you can select
CAMERA
(rear view
camera setting).
#
When the multi-channel processor (e.g., DEQ-
P7650) is connected to this unit, you can operate
D.ATT
and
AUDIO RESET
instead of
REAR SP
.
Setting the clock
Use these instructions to set the clock.
1
Use MULTI-CONTROL to select CLOCK.
Refer to
Adjusting initial settings
on this page.
2
Push MULTI-CONTROL left or right to
select the segment of the clock display you
wish to set.
Pushing
MULTI-CONTROL
left or right will se-
lect one segment of the clock display:
Hour
—
Minute
As you select segments of the clock display,
the selected segment blinks.
3
Push MULTI-CONTROL up or down to
put a clock right.
Note
You can match the clock to a time signal by
pressing
MULTI-CONTROL
.
!
If
00
to
29
, the minutes are rounded down.
(e.g.,
10:18
becomes
10:00
.)
!
If
30
to
59
, the minutes are rounded up. (e.g.,
10:36
becomes
11:00
.)
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
!
If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1
Use MULTI-CONTROL to select FM STEP.
Refer to
Adjusting initial settings
on this page.
2
Press MULTI-CONTROL to select the FM
tuning step.
Pressing
MULTI-CONTROL
repeatedly will
switch the FM tuning step between 50 kHz
and 100 kHz. The selected FM tuning step will
appear in the display.
Operating this unit
En
48
Section
02
