1
Use MULTI-CONTROL to select PEQ-2.
Refer to
Introduction of DSP adjustments
on
page 67.
#
Adjusted
PEQ-2
settings are memorized in
CUSTOM 1
.
2
Push MULTI-CONTROL left or right to
select the desired item.
FRONT
(speakers)
—
LOW
(bands)
—
200
(cen-
ter frequency)
—
0
(equalizer level)
—
WIDE
(Q
factor)
3
Push MULTI-CONTROL up or down to
select the speaker to be adjusted.
FRONT
(front speakers)
—
CENTER
(center
speaker)
—
REAR
(rear speakers)
#
You cannot select speakers whose size is set
at
OFF
. (Refer to
Setting the speaker setting
on
page 73.)
4
Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to select
the equalizer band to be adjusted.
LOW
(low)
—
MID
(mid)
—
HI
(high)
5
Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to select
the center frequency of selected band.
40HZ
—
50HZ
—
63HZ
—
80HZ
—
100HZ
—
125HZ
—
160HZ
—
200HZ
—
250HZ
—
315HZ
—
400HZ
—
500HZ
—
630HZ
—
800HZ
—
1KHZ
—
1.25KHZ
—
1.6KHZ
—
2KHZ
—
2.5KHZ
—
3.15KHZ
—
4KHZ
—
5KHZ
—
6.3KHZ
—
8KHZ
—
10KHZ
—
12.5KHZ
6
Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to ad-
just the equalizer level.
+6
to
–
6
is displayed as the level is increased
or decreased.
7
Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to select
the desired Q factor.
WIDE
(wide)
—
NARROW
(narrow)
#
You can adjust parameters for each band of
the other speakers in the same way.
8
Press BAND to return to the ordinary
display.
Note
You can select a center frequency for each band.
You can change the center frequency in 1/3-oc-
tave steps, but you cannot select frequencies that
have intervals shorter than 1 octave among the
center frequencies of the three bands.
Available accessories
En
78
Section
03