Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
FULL
) or subwoofer (
SUB W
)
connection. If you switch the rear output set-
ting to
SUB W
, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
!
When the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you
cannot operate this function.
1
Use MULTI-CONTROL to select REAR SP.
Refer to
Adjusting initial settings
on page 52.
2
Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL
will switch be-
tween
FULL
(full-range speaker) and
SUB W
(subwoofer) and that status will be displayed.
#
When no subwoofer is connected to the rear
output, select
FULL
(full-range speaker).
#
When a subwoofer is connected to the rear
output, select
SUB W
(subwoofer).
Notes
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output
on page
45).
!
If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
!
Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the ever scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1
Use MULTI-CONTROL to select
EVERSCROLL.
Refer to
Adjusting initial settings
on page 52.
2
Press MULTI-CONTROL to turn the ever
scroll on.
#
To turn the Ever Scroll off, press
MULTI-CONTROL
again.
Setting the TV signal
When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
!
About your country TV signal, consult with
your nearest Pioneer dealer.
1
Use MULTI-CONTROL to select
TV SIGNAL.
Refer to
Adjusting initial settings
on page 52.
2
Press MULTI-CONTROL to select an ap-
propriate TV signal.
PAL
—
SECAM
Correcting distorted sound
Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to
LOW
. Normally, leave the set-
ting at
HIGH
to ensure quality sound.
1
Use MULTI-CONTROL to select D.ATT.
Refer to
Adjusting initial settings
on page 52.
Operating this unit
En
55
Section
02
Operating
this
unit
