Pioneer DVD-R100, Руководство по эксплуатации

Страница: 6 / 44

6
<DRC1146>
En
SAFETY INSTRUCTIONS
Disc-related
7
Recommended DVD-R disc
Please confirm with a store or on our
home page.
÷
Avoid touching or scratching the signal
surface (shiny side) of the disc
÷
Hold the disc by the edges or by the
center hold and one edge
÷
Do not affix paper or labels to the disc
÷
Discard warped or
cracked discs as
they may cause
d a m a g e t o t h e
drive
÷
Av o i d s p e c i a l l y
shaped discs such
a s h e a r t s o r
polygons
÷
Remove dust or
lint from the disc
with a soft cloth by
wiping from the
inside to the outside edge rather than
in a circular motion
÷
Do not use record-cleaning or anti-static
agents as the solutions may cause
damage to a disc
DVD-R Discs
7
When data cannot be recorded or
errors occur during recording:
÷
Is the disc one that may be used with
this device?
÷
Has a sufficiently large writing area
been secured?
÷
Was the DVD-R finalized (made so that
no more writing is possible)?
÷
Has the disc been inserted correctly
with its label side facing up and writing
side down?
÷
Is the disc dirty or scratched?
7
The device cannot read a disc that
has been recorded.
÷
Is the disc one that may be used with
this device?
÷
Is an unwritten disc installed?
÷
Note that CDs cannot be read.
÷
Is the disc dirty or scratched?
÷
It is possible that condensation has
formed on the optical components or
on the disc. (Wait 1 to 2 hours before
attempting to use the device again.)
* For other issues pertaining to DVD-R
disc writing, please refer to the manual
for your application software.
INSTALLATION-RELATED PRECAUTION
Be sure to remember the following points during the installation of your DVD-R100.
÷
Only a single DVD-R100 can be mounted on the 100-disc-changer; the DRM-1004.
÷
The DVD-R100 has two drive bays.
The only drive location where the DVD-R100 can only be installed is drive bay #2
(2nd from the bottom).
÷
Do not block the ventilation hole (part of DRIVE 1) that is on the back of the DVD-
R100. If dust adheres to the ventilation hole while the unit is in use, clean it with a
vacuum cleaner or similar device.