43
DV-420V-K
5
6
7
8
5
6
7
8
A
B
C
D
E
F
NOTE
NOTE
1. In case of the Clamper Ass'y installation, install correctly
as Fig. 2-5-B.
2-6: INSULATOR (R) (Refer to Fig. 2-6-A)
1. Remove the Insulator (R).
Traverse Ass'y
Fig. 2-5-B
Check Hock
Clamper
Insulator (R)
Fig. 2-6-A
1. When installing the Rack Feed Ass'y, push both ends to
align the teeth as shown Fig. 2-7-B. Then install it.
2. In case of the Gear Motor installation, check if the value
of the Fig. 2-7-C is correct.
3. After the assembly of the Traverse Ass'y, hook the wire
on the Traverse Ass'y as shown Fig. 2-7-D.
Push
Rack Feed Ass'y
Push
Fig. 2-7-B
7.0
0.1mm
Gear Motor
Feed Motor
Check Hook
2-7: SWITCH PCB ASS'Y/GEAR MIDDLE/GEAR FEED/RACK
FEED ASS'Y/FEED MOTOR ( Refer to Fi g . 2-7-A)
1. Remove the screw (1).
2. Remove the Gear Feed.
3. Remove the Gear Middle.
4. Remove the screw (2).
5. Remove the Rack Feed Ass'y.
6. Remove the 2 screw (3).
7. Remove the Feed Motor.
2-8: FFC WIRE HANDLING
1. Do not make the folding lines except the specified
positions for the FFC.
• Screw Torque: 1.3
0.3kgf•cm (Screw (2))
• Screw Torque: 2.5
0.3kgf•cm (Screw (1))
• Screw Torque: 1.0
0.3kgf•cm (Screw (3))
Fig. 2-7-A
Feed Motor
Gear Motor
Gear Middle
Gear Feed
(3)
(1)
Fig. 2-7-C
Safety surface for pressing
of the insert.
Fig. 2-7-D
Traverse Ass'y
Check Hook
Check Hook
• Loosen the wire in the direction of the arrow.
[ 22 pin FFC ]
Fold
Printing Surface
52
1mm
Reinforcement Plate
To Pick Up PCB
(3)
Black
Red
Fig. 2-8
Pickup leneses
GEM1004
GED-008
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299