41
DV-420V-K
5
6
7
8
5
6
7
8
A
B
C
D
E
F
NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the disassembly
is done. If the repair is needed except listed parts,
replace the DVD MECHA ASS'Y.
2-1: TRAY (Refer to Fig. 2-1-A)
1. Set the Tray opened.
(Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY)
2. Unlock the 2 supports (1) and draw it while sagging the
Tray.
NOTE
• If RACK LOADING does not move following
the direction, it cannot Ass'y (1)
Loader Ass'y
Fig. 2-1-A
(1)
Push to Sag
Push to Sag
Tray
NOTE
1. In case of the Traverse Ass'y, install it from (1) to (3) in
order.
(Refer to Fig. 2-2-B)
2. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-2-C.
Rack Loading
Check Lock
Fig. 2-2-B
Loader Ass'y (Bottom Side)
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 2-1-B so that the each markers are met.
2-3: LOADING MOTOR PCB ASS'Y/LOADING BELT
(Refer to Fig. 2-3-A)
2-2: TRAVERSE ASS'Y (Refer to Fig. 2-2-A)
1. Remove the screw (1).
2. Unlock the 2 supports (2).
3. Remove the Insulator (R) from the Loader Sub Ass'y.
4. Remove the Traverse Ass'y.
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (2))
• Screw Torque: 2.0 ± 0.3kgf•cm
(1)
(2)
(2)
Traverse Ass' y
Insulator (R)
Fig. 2-2-A
Fig. 2-2-C
Loader Ass'y
1. Remove the Loading Belt.
2. Unlock the 2 supports (1).
3. Remove the Loading Motor PCB Ass'y.
4. Remove the 2 screws (2).
5. Remove the Loading Motor.
6. Remove the Pulley Motor.
Fig. 2-3-A
Loader Sub Ass'y
Pulley Motor
Loading Motor
Loading Motor PCB Ass'y
Loading Belt
(2)
(2)
(1)
(1)
Fig. 2-1-B
Tr
a
y
R
a
ck Lo
a
ding
• If RACK LOADING doe
s
not move following
the direction, it c
a
nnot A
ss
'y (1)
Lo
a
der A
ss
'y
2. REMOVAL OF DVD DECK PARTS
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299