16
<DRC1285>
En
REAR
1
Rear plates
These plates cover the space for attaching the connector
panels.
2
Rear access door
3
SE drive SCSI ports (attached connector panel)
4
SCSI ID switch (ID)
This switch is used to assign the changer SCSI ID. If you
would like to decrement the displayed SCSI ID, push the
small switch just above the numeric display by a nib. And
if you would like to increment, push the small switch just
below the numeric display. Note that SCSI ID is set to ‘6’
at the time of shipment.
5
SCSI termination switch (TERM)
This switch is for SCSI termination. Note that this switch
is set ON at the time of shipment and it must be kept ON
during the changer installation. But when the SCSI bus
connection is completed and the changer is not the last
device on the SCSI bus, it must be set OFF certainly.
REAR ACCESS DOOR INSIDE
Names and functions of individual parts
1
2
TERM
OFF
ON
ID
C H A N G E R S C S I
ON
OFF
GND
POWER
A C I N
7
8
3
6
5
4
9
6
Changer SCSI ports (CHANGER SCSI)
7
Power switch (POWER)
This switch is used to turn the power to the changer on
and off.
8
Power inlet (AC IN)
The power cord is inserted into this power inlet. (Note
that you should always be sure to use only the power cord
provided with your changer.)
9
Rear bays
DRM-7000
For use with disc magazines: M8 – M15
For use with optional units/modules: Bays #1 – 16
DRM-3000
For use with disc magazines: M4 – M7
For use with optional units/modules: Bays #1 – 8
Содержание DRM-300
Страница 2: ...2 DRC1285 En ...
