Pioneer DEH-P6800MP, Руководство по эксплуатации

Страница: 62 / 152

1 Use MULTI-CONTROL to select Dimmer.
Dimmer appears in the display.
2 Press MULTI-CONTROL to turn dimmer
on.
ON appears in the display.
# To turn dimmer off, press MULTI-CONTROL
again.
Adjusting the brightness
You can adjust the display brightness. Initially
this mode is set to 12.
1 Use MULTI-CONTROL to select
Brightness.
Brightness appears in the display.
2 Push MULTI-CONTROL left or right to
adjust the brightness level.
Each time MULTI-CONTROL is pushed left or
right, brightness level increases or decreases.
0 15 is displayed as the level is increased or
decreased.
# When dimmer is set to ON, the brightness
level can be adjusted 0 10 .
Setting the rear output and
subwoofer controller
This unit s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker ( Rear SP :F.Range ) or subwoo-
fer ( Rear SP :S/W ) connection. If you switch
the rear output setting to Rear SP :S/W , you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection ( Rear SP :F.Range ).
1 Use MULTI-CONTROL to select
Sub/W control.
Sub/W control appears in the display.
2 Press MULTI-CONTROL to switch the
rear output setting.
Pressing MULTI-CONTROL will switch be-
tween Rear SP :F.Range (full-range speaker)
and Rear SP :S/W (subwoofer) and that status
will be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :F.Range .
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S/W .
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output on page
57).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Use MULTI-CONTROL to select Mute.
Mute appears in the display.
Initial Settings
En
62
Section
14