2
Press MULTI-CONTROL to display the
setting mode.
3
Turn MULTI-CONTROL to select the AM
tuning step.
Turning
MULTI-CONTROL
will switch the AM
tuning step between 9 kHz and 10 kHz. The se-
lected AM tuning step will appear in the dis-
play.
#
You can also perform the same operations by
pushing
MULTI-CONTROL
up or down.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1
Use MULTI-CONTROL to select
WARNING TONE.
2
Press MULTI-CONTROL to turn warning
tone on.
#
To turn warning tone off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
Auxiliary devices connected to this unit can be
activated individually. Set each AUX source to
ON when using. For more information about
connecting or using auxiliary devices, refer to
Using the AUX source
on page 30.
1
Use MULTI-CONTROL to select AUX1/
AUX2.
2
Press MULTI-CONTROL to turn AUX1/
AUX2 on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
’
s headlights are turned on. You
can turn the dimmer on or off.
1
Use MULTI-CONTROL to select DIMMER.
2
Press MULTI-CONTROL to turn dimmer
on.
#
To turn dimmer off, press
MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put) can be used for full-range speaker (
FULL
)
or subwoofer (
SUB W
) connection. If you
switch the rear output setting to
SUB W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
FULL
).
1
Use MULTI-CONTROL to select
SW CONTROL.
2
Press MULTI-CONTROL to display the
setting mode.
#
Press
BACK
to return to the previous display.
3
Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
SUB W
(subwoofer)
—
FULL
(full-range speak-
er)
#
When no subwoofer is connected to the rear
output, select
FULL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
SUB W
.
Initial Settings
En
27
English
Section
04