Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
Flat
, can be adjusted to a fine de-
gree (nuance control).
1
Use M.C. to select EQ 1.
Refer to
Introduction of audio adjustments
on
page 20.
2
Turn M.C. to select an equalizer curve.
3
Turn LEVER to adjust the equalizer
curve.
+6
to
–
6
is displayed as the equalizer curve is
increased or decreased.
#
The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
#
The equalizer curve with all frequencies set to
0
cannot be adjusted.
Adjusting the 16-band graphic
equalizer
You can adjust the level of each band for the
Custom1
and
Custom2
equalizer curves.
!
A separate
Custom1
curve can be created
for each source. If you make adjustments
when a curve other than
Custom2
is se-
lected, the equalizer curve settings will be
recorded in
Custom1
.
!
A
Custom2
curve that is common for all
sources can be created. If you make adjust-
ments when the
Custom2
curve is se-
lected, the
Custom2
curve will be updated.
1
Recall the equalizer curve you want to
adjust.
Refer to
Recalling equalizer curves
on the pre-
vious page.
2
Use M.C. to select EQ 2.
Refer to
Introduction of audio adjustments
on
page 20.
3
Turn M.C. to select the equalizer band
to adjust.
20
—
31.5
—
50
—
80
—
125
—
200
—
315
—
500
—
800
—
1.25k
—
2k
—
3.15k
—
5k
—
8k
—
12.5k
—
20k
(Hz)
4
Turn LEVER to adjust the level of the
equalizer band.
+6
to
–
6
is displayed as the level is increased
or decreased.
#
You can then select another band and adjust
the level.
5
Press BAND/
to cancel the 16-band
graphic equalizer adjustment.
Adjusting loudness
Loudness compensates for deficiencies in the
low-frequency and high-frequency ranges at
low volume.
1
Use M.C. to select LOUD in the audio
function menu.
Refer to
Introduction of audio adjustments
on
page 20.
2
Press M.C. to turn loudness on.
#
To turn loudness off, press
M.C.
again.
Adjusting source levels
With SLA (source level adjustment), the vo-
lume levels of each source can be adjusted to
prevent significant differences between
sources.
!
Settings are based on the FM volume level,
which remains unchanged.
1
Compare the FM volume level with the
level of the source you wish to adjust.
2
Use M.C. to select SLA in the audio
function menu.
Refer to
Introduction of audio adjustments
on
page 20.
En
28
Section
02
Operating this unit
Содержание DEH-80PRS Series
Страница 1: ...Operation Manual CD RDS RECEIVER DEH 80PRS English ...
Страница 67: ......
