3
Turn MULTI-CONTROL to select the AM
tuning step.
Turning
MULTI-CONTROL
will switch the AM
tuning step between 9 kHz and 10 kHz. The se-
lected AM tuning step will appear in the dis-
play.
#
You can also perform the same operations by
pushing
MULTI-CONTROL
up or down.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone sounds. You can
turn off the warning tone.
1
Use MULTI-CONTROL to select
WARNING TONE.
2
Press MULTI-CONTROL to turn warning
tone on.
#
To turn warning tone off, press
MULTI-CONTROL
again.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1
Use MULTI-CONTROL to select AUX.
2
Press MULTI-CONTROL to turn AUX on.
#
To turn AUX off, press
MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP :FULL
/
PREOUT :REAR
) or subwoofer
(
REAR SP :SUB W
/
PREOUT :SUB W
) connec-
tion. If you switch the rear output setting to
REAR SP :SUB W
, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP :FULL
). When rear
output is connected to full range speakers
(when
REAR SP :FULL
is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller
’
s (low pass filter,
phase) built-in
PREOUT :SUB W
or the auxili-
ary
PREOUT :REAR
.
1
Use MULTI-CONTROL to select
SW CONTROL.
2
Press MULTI-CONTROL to display the
setting mode.
#
Press
BACK
to return to the previous display.
3
Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press
MULTI-CONTROL
repeatedly to switch
the segment in the following order:
REAR SP
(rear speaker setting)
—
PREOUT
(RCA output setting)
4
Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
When
REAR SP
(rear speaker setting) is se-
lected.
REAR SP :SUB W
(subwoofer)
—
REAR SP :FULL
(full-range speaker)
When
PREOUT
(RCA output setting) is se-
lected.
PREOUT :SUB W
(subwoofer)
—
PREOUT :REAR
(full-range speaker)
#
When no subwoofer is connected to the rear
output, select
REAR SP :FULL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
REAR SP :SUB W
.
Initial Settings
En
23
English
Section
04