Before installing this
product
!
This product is for vehicles with a 12-volt
battery and negative grounding. Check the
battery voltage of your vehicle before instal-
lation.
!
To avoid shorts in the electrical system, be
sure to disconnect the (
–
) battery cable be-
fore beginning installation.
To prevent damage
!
When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector.
!
This product cannot be installed in a vehi-
cle without ACC (accessory) position on
the ignition switch.
ACC ON
S
TA
RT
O
FF
ON
S
TA
RT
O
FF
ACC position
No ACC position
!
When replacing the fuse, be sure to only
use a fuse of the rating prescribed on the
fuse holder.
!
To avoid a short-circuit, cover the discon-
nected lead with insulating tape. Insulate
the unused speaker leads without fail.
There is a possibility of a short-circuit if the
leads are not insulated.
!
Attach the connectors of the same color to
the corresponding colored port, i.e., blue
connector to the blue port, black to black,
etc.
!
Refer to the owner
’
s manual for details on
connecting the power amp and other units,
then make connections accordingly.
!
Since a unique BPTL circuit is employed,
do not directly ground the
*
side of the
speaker lead or connect the
*
sides of the
speaker leads together. Be sure to connect
the
*
side of the speaker lead to the
*
side of the speaker lead on this navigation
system.
!
If the RCA pin jack on this product will not
be used, do not remove the caps attached
to the end of the connector.
!
Speakers connected to this navigation unit
must be high-power with minimum rating
of 50 W and impedance of 4 to 8 ohms.
Connecting speakers with output and/or
impedance values other than those noted
here may result in the speakers catching
fire, emitting smoke, or becoming da-
maged.
Notice for the blue lead
!
A signal is output through the blue lead to
control the antenna of your vehicle. The
timing varies depending on the setting. (For
more detailed information on changing
[
Auto ANT
] mode, refer to the operation
manual.)
!
When [
Auto ANT
] mode is set to [
Radio
],
the vehicle
’
s antenna can be stowed or
turned off by following the instructions
below.
—
Change the source from radio (AM or
FM) to another source
—
Turn the source off
—
Turn off the ignition switch (ACC OFF)
Connecting the System
En
5
English
Section
02
