1
Side bracket (small)
2
Flush surface screw (5 mm × 6 mm)
2
Install the unit into the dashboard.
Insert the mounting sleeve into the dashboard.
And then secure the mounting sleeve by using
a screwdriver to bend the metal tabs (90°) into
place.
182
53
1
3
4
2
1
Dashboard
2
Mounting sleeve
3
Side bracket
4
Screw (2 mm × 3 mm)
DIN Rear-mount
1
Determine the appropriate position
where the holes on the bracket and the
side of the unit match.
When installing in a shallow space, use the
following screw holes.
1
1
1
Use binding screws (4 mm × 3 mm) only.
2
Tighten two screws on each side.
Use any of binding screws (4 mm × 3 mm),
binding screws (5 mm × 6 mm) or flush sur-
face screws (5 mm × 6 mm), depending on
the shape of screw holes in the bracket.
1
2
3
1
Screw
2
Dashboard or console
3
Factory radio mounting bracket
Note
In some types of vehicles, discrepancy may occur
between the unit and the dashboard. If this hap-
pens, use the supplied frame to fill the gap.
Removing the unit
Extend top and bottom of the trim ring out-
wards to remove the trim ring. And then loos-
en the screws (2 mm × 3 mm) to remove the
mounting sleeve.
!
When reattaching the trim ring, push the
trim ring onto the unit until it clicks. (If the
trim ring is attached upside down, the trim
ring will not fit properly.)
1
3
2
1
Mounting sleeve
2
Screw (2 mm × 3 mm)
3
Trim ring
En
54
Section
12
Installation
130.com.ua
Autogood products «130»
