Pioneer A-10AE, Инструкция по эксплуатации

Страница: 10 / 52

10
Preparations
Press Í STANDBY/ON on this unit.
Depending on the speakers you connect, you may need to
change the speaker impedance setting on this unit. Refer to
the page describing speaker connection (
 p7), and do the
following procedures if the change is required.
1. Press and hold DIRECT until some indicators, such as
the input source indicators "CD/SACD" and "LINE 1", start
blinking on the unit.
0
The unit has switched to the setting mode when the
indicators blink and the current setting is displayed.
2. Take your finger off DIRECT for a moment.
3. Press and hold DIRECT again to change the setting. The
following content switches alternately by pressing and
holding the button.
- 4
≠
: "CD/SACD" and "LINE 1" indicators are blinking
- 8 ≠ (default value): "CD/SACD", "LINE 1", "LINE 2",
and "LINE 3" indicators are blinking
0
The setting mode ends after 5 seconds elapse with no
operations performed.
Before play
Turn on the power of the unit
Speaker impedance settings
1
3"
1
2
4Ω 8Ω
3"
3
SN29403412_A-10AE_En_1804XX.book 10 ページ ２０１８年５月１４日 月曜日 午前１１時３分