Important
!
When this unit is installed in a vehicle without
ACC (accessory) position on the ignition
switch, red cable must be wired to the term-
inal that can detect the operation of the igni-
tion key. Otherwise, battery drain may result.
ON
S
T
A
R
T
O
FF
ACC position
No ACC position
!
Use of this unit in conditions other than the
following could result in fire or malfunction.
—
Vehicles with a 12-volt battery and negative
grounding.
—
Speakers with 50 W (output value) and 4
ohm to 8 ohm (impedance value).
!
To prevent a short-circuit, overheating or mal-
function, be sure to follow the directions
below.
—
Disconnect the negative terminal of the
battery before installation.
—
Secure the wiring with cable clamps or ad-
hesive tape. To protect the wiring, wrap ad-
hesive tape around them where they lie
against metal parts.
—
Place all cables away from moving parts,
such as gear shift and seat rails.
—
Place all cables away from hot places,
such as near the heater outlet.
—
Do not pass the yellow cable through a
hole into the engine compartment to con-
nect to a battery.
—
Cover any disconnected cable connectors
with insulating tape.
—
Do not shorten any cables.
—
Never cut the insulation of the power cable
of this unit in order to share the power
with other devices. Current capacity of the
cable is limited.
—
Use a fuse of the rating prescribed.
—
Never wire the speaker negative cable di-
rectly to ground.
—
Never band together multiple speaker
’
s ne-
gative cables.
!
Control signal is output through blue/white
cable when this unit is powered on. Connect it
to an external power amp
’
s system remote
control or the vehicle
’
s auto-antenna relay
control terminal (max. 300 mA 12 V DC). If the
vehicle is equipped with a glass antenna, con-
nect it to the antenna booster power supply
terminal.
!
Never connect blue/white cable to external
power amp
’
s power terminal. Also, never con-
nect it to the power terminal of the auto anten-
na. Otherwise, battery drain or malfunction
may result.
!
Black cable is ground. This cable and other
product
’
s ground cable (especially, high-cur-
rent products such as power amp) must be
wired separately. Otherwise, fire or malfunc-
tion may result if they are accidentally de-
tached.
Connections
En
13
English
Section
03
