Pioneer Eclipse PE-200BU, Руководство оператора

Страница: 3 / 12

Instructions
Application
The PE-200BU High Speed Burnisher is used to achieve and/or maintain a high gloss appearance on an established
floor finish. The high pad revolution of the floor burnisher combined with a good polishing pad will turn properly
established cleaned floor finish into a high gloss, hardened finish known as the “wet look shine”. The pads
recommended are the image beige or white synthetic pads or the natural hogs hair blended pads.
Preparation of Surface
Before each use of this machine, the floor must be dust mopped with a treated mop and if necessary clean the floor with
a damp mop, using a solution of water and neutral cleaner.
Prepare the Machine for Operation
WARNING: To prevent injury, always remove the electrical plug from the electrical outlet before changing the polishing
pad and before leaving the machine.
With the handle locked, tip the machine back until the handle is lying flat on the floor.
To remove the pad-lock pad holder from the flexible pad driver, grasp the center support with your thumb and
forefinger and turn the collar counter-clockwise. (Fig 1)
Place a clean or new 20” buffing pad over the alignment ring on the pad holder.
Replace the collar by turning clockwise until snug. (Fig 2)
Step back and lift the burnisher to the upright position.
Connect the power cord into a grounded, 3-wire outlet.
The PE-200BU should be operated with the handle in the unlocked “floating” position to provide excellent
maneuverability and automatic pad contact.