Pioneer Eclipse Express Power Glide, Руководство оператора

Страница: 15 / 41

Plastic Cover Removal
The back panel has one
screw knob in the center of
the back cover. Remove the
screw knob and pull the
cover toward you from the
top. The back cover will
come off and expose the
electronics of the machine.
The motor cover is attached to the
shroud with (4) 5/16-18 hex head
bolts. Using a 1/2 inch wrench,
remove the bolts and remove the
motor cover.
The Battery Cover is hinged at the
dash for easy battery
maintenance. Lift the bottom of
the battery cover, at the shroud,
up and swing the cover. Place
the hood support rod into the hole
on the battery connection bracket
to hold the hood up.
FOR YOUR SAFETY: NEVER OPERATE BURNISHER
WITHOUT ALL COVERS IN PLACE!
Battery Maintenance
The batteries are deep cycle 12 volt batteries. The
lifetime of the batteries is limited by the number of charges
the batteries receive. To get the most life from the
batteries, charge them when the battery discharge LED
(Red) starts to blink (20% charge left). Use only the
on-board battery charger supplied to charge the batteries.
Periodically clean the top surface of the batteries and the
terminals, and check for loose connections. Use a strong
solution of baking soda and water. Brush the solution
sparingly over the battery tops, terminals, and cable
clamps. DO NOT ALLOW ANY BAKING SODA
SOLUTION TO ENTER THE BATTERIES! Use a wire
brush to clean the terminal posts and cable connectors.
After cleaning, apply a coating of clear battery post
protectant to the terminals and the cable connectors.
Keep the tops of the batteries clean and dry.
To prevent a possible short circuit, keep all metallic objects
off the top of the batteries. Replace any worn or damaged
wires.
Never add acid to the batteries, only distilled water.
Always keep the battery caps on, except when adding
water or taking hydrometer readings.
Check the electrolyte level in each battery cell before and
after charging, and after every 50 hours of operation. Do
not charge the batteries
unless the fluid is slightly
above the battery plates. If
needed, add just enough
distilled water to cover the
plates.
Never add acid to
the batteries. Do not
overfill.
Measuring the specific gravity, using a hydrometer, is a
way to determine the charge level and condition of the
batteries. If one or more of the battery cells test lower
than the other battery cell (0.050 or more), the cell is
damaged, shorted, or is about to fail.
Static Drag Chain
A static drag chain prevents the buildup of static electricity
in the machine. The chain is attached to the frame.
Make sure the chain is
always touching the
floor.
Repacking the Machine
Refer to Unpacking section on page 5 and repack
machine using original packing materials and container.
Transporting the Machine
When shipping the machine, make sure the batteries are
disconnected and the machine is secured in the
transporting vehicle with the brake set.
12