Pioneer Eclipse Express Power Glide, Руководство оператора

Страница: 11 / 41

Pad Pressure Adjustment Lever
The pad pressure adjustment
lever adjusts the amount of
down pressure exerted on the
burnish shroud. The pad
pressure lever has 3 positions
(light, medium, heavy).
NOTE: When using a new pad
or when buffing freshly applied wax, the light setting
should be used. As the pad breaks in and/or the wax
starts to harden, the pad pressure lever can be adjusted to
keep the pad pressure gauge in the green operational
area. If the pad pressure adjustment lever is in the heavy
position and the pad pressure gauge is in the white area,
this indicates the burnish pad either needs to be changed
or has become clogged with dirt and wax.
Fuses
The PowerGlide Express has 2 power fuses and 2 logic
fuses. One power fuse is ANL 100 amp, which protects
the burnish motor. The other power fuse is ANL 50 amp,
which protects the traction motor and controller. The two
logic fuses are located on the dash panel. Both are rated
at 3 amps. One protects the actuator and the other
protects the logic circuit of the machine.
Logic Fuses
Power Fuses
E-Stop Switch
The emergency stop switch is provided for added safety.
Press the RED knob to stop all function of the burnisher
and come to an immediate stop. To reset the emergency
stop switch pull up on the red knob.
Raise/Lower Switch
The Raise/Lower switch controls the position of the
burnish shroud.
Lower Shroud for burnish mode: Press the bottom of the
switch. The shroud will lower to the burnishing position.
Raise Shroud for transport/Pad Change mode: Press the
bottom of the switch. The shroud will raise to the
transport/Pad Change position.
Burnish On/Off Switch
The burnish On/Off switch controls the burnish pad motor.
Turn the burnish pad on and start burnishing: Press the
top of the switch. The green light is ON.
Turn the burnish pad off and stop burnishing: Press the
bottom of the switch. The green light is OFF.
NOTE: The burnish pad will not begin to turn until the
accelerator is engaged by pushing or pulling the
accelerator handle. When the accelerator is released the
pad will stop turning within 5 seconds.
8