Pioneer Eclipse Express Power Glide, Руководство оператора

Страница: 13 / 41

How the Machine Works
The Burnish components of the machine are:
Burnish pad holder
Burnish pad
Burnish motor
Dust Collection Box
As the machine moves forward, the burnish pad shines
the floor. Any excess dirt or wax gets picked up by the
pad and distributed into the dust collection box via the
dust collection system.
Pre-Operation Checklist
Before operating the machine:
Check that the Burnish Switch is in the off position.
Check the pad holder to ensure there are no breaks
or cracks.
Check correct connection of the batteries.
Check that the Dust Collection Box is empty and
latched into position.
Check that the E-stop is pulled up in the operating
position.
Turning on the Machine
1. Complete pre-operation check.
2. Turn the Key to the ON position.
3. Lower the shroud to the burnish mode position.
4. Turn on the burnish switch and push or pull the
handle in the forward/reverse direction.
5. Adjust pad pressure lever as needed.
Changing Direction
The direction the machine is traveling can be changed by
pushing or pulling the accelerator in the opposite direction.
The direction can be changed while the machine is in
motion or stationary. If the machine is in motion and the
direction is switched, the vehicle will slow down and
change direction.
Stopping and Turning Off Machine
To stop the machine, release the accelerator and the
machine will smoothly break to a stop and after 3 seconds
the burnish motor will stop. When turning the machine off,
turn off the burnish switch and then turn off the key switch.
In an emergency situation the E-Stop can be used to
immediately stop the vehicle and stop the burnish motor.
Installing/Changing Burnishing Pad
1. Make sure the
Burnish Switch is
OFF.
2. Raise the shroud to
the transport/pad
change position. Lift
on the front of the shroud and
tilt shroud into the pad change
position.
3. Remove the center device
by turning counterclockwise
and carefully remove the old
pad from the Velcro material.
CAUTION! CAREFULLY INSPECT THE PAD HOLDER
FOR CRACKS OR DAMAGE! REPLACE IF NECESSARY.
4. Pull center from new pad, align pad on pad holder
and secure with centering device by turning
clockwise.
5. Press pad firmly onto
Velcro.
6. Lift the front of the shroud
and lift the shroud release
lever and SLOWLY let the
shroud return to the down
position.
CAUTION! KEEP HOLD OF THE DECK TO AVOID
INJURY!
10