NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
© 2014, Pinnacle Products International, Inc.
Indirect Fired Heater User’s Manual
®
Maintenance
Long Term Storage:
Models 100T-IDF-EU / 170T-IDF-EU:
1. Drain fuel through the drain plug in the bottom
of the fuel tank.
2.
Using a small amount of paraffin, rinse and
swirl the paraffin inside of the fuel tank, empty
the tank fully.
IMPORTANT: Never store leftover paraffin
between seasons, using old fuel can damage
heater.
Service:
DO NOT TAMPER WITH THE UNIT. HAVE
A COMPETENT SERVICEMAN MAKE ANY
NECESSARY ADJUSTMENT OR REPAIRS.
Use only original equipment parts. The use of
alternate or third party components can cause
unsafe operating conditions.
We suggest following a maintenance schedule as
follows:
FUEL / FUEL TANK:
Flush tank every 200 hours of operation or as
needed.
DO NOT flush with water, use fresh paraffin only.
NOZZLES:
Nozzles should be cleaned or replaced at least
once per heating season. Contaminated fuel could
make this necessary immediately. To clean dirt
from nozzle, blow compressed air through nozzle
front. It may be necessary to soak the nozzle in
paraffin to loosen any dirt particles.
SPARK PLUG:
Clean and re-gap every 600 hours of operation, or
replace as needed. After removing the spark plug,
clean the terminals with a wire brush.
See Figure 8.
PHOTOCELL:
The photocell should be cleaned using a cotton
swab dipped in alcohol or water at least once
per heating season, or more depending on
conditions. See Figure 17.
11
TIP: Follow the long term storage
instructions to flush the tank.
Never service heater while it is
plugged in or hot!
WARNING
X
X
Figure 8
Figure 9
