NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
© 2014, Pinnacle Products International, Inc.
Indirect Fired Heater User’s Manual
®
Operation
Starting the Heater: (Ignition)
1. Fill the tank with paraffin or other approved
fuel until needle on fuel gauge points to “F”.
2. Replace fuel cap and tighten firmly.
3. Connect the heater to a three prong
(grounded) power source. You must use a
three prong (grounded) extension cord that is
at least 1.8 meters long and is properly rated
for this service.
4. Move power switch to “On” position. The LED
displays will illuminate.
5. The left display is the setting temperature.
Use the thermostat knob to raise or lower the
setting temperature as desired.
6. The right display is the ambient room
temperature.
7. The heater will ignite once the setting
temperature is higher than the ambient room
temperature.
NOTE: If if the heater still does not ignite,
refer to “Troubleshooting Guide” on page 12
.
Stopping / Restarting Heater:
1. To stop the heater, move the power switch to
the “Off” position and unplug the power cord.
2. To restart the heater; wait 10 seconds and
follow ignition steps.
10
TIP: If the heater does not ignite, the
thermostat may be set too low. Turn
the control knob to a higher setting until the
heater ignites. If the heater does not ignite;
move switch to “Off” position, check steps 1-3
above and then move switch to “On” position.
Thermostat Knob
Power Switch
Setting Temperature
Room Temperature
Control Panel
Figure 7
