Pinnacle EDGE EX33, Инструкции по установке

Страница: 25 / 25

© 2017 Pinnacle Architectural Lighting
12655 E. 42nd Ave. #50 Denver, CO 80239 Phone: 303.322.5570 Fax: 303.322.5568
25 of 25
www.pinnacle-ltg.com
Snap In Lens
Lensing detail sheet
Lens Installation Lens Removal
1. Begin at one end of the fixture and insert lens into appropriate position
where it will snap into place.
2. Gradually insert the lens along the length of the fixture, snapping it into
place as you go.
3. If at any point the lens becomes difficult to insert press slightly into the
center of the lens in order to allow for it to flex, temporarily decreasing the
width of the lens. 1. Insert a rigid object approx. 1/16” thick, such as a quarter, into the edge
between the lens and the fixture, approx. 1-2” from the end of the lens.
(6” for regress lens)
2. Using said object, gently pry lens away from fixture until it is released
from the mounting edge.
3. Once the section is released, start at one end of the fixture and pull the
lens out of the fixture.
EdgeEX33_44_Booklet_January 2017
Fixture End
Snap-In Lens
Note: Low temperatures can effect the lens material,
making it brittle. Please allow the lenses to warm
to room temperature before installation.
Approx. 1-2” Away
From Fixture End
Snap-In Lens
Flexed for Installation
Approx. location
to allow for flex
EDGE
Return to
Main Menu