•
Place the Cap of Water Tank on the Water Tank.
•
Remove barrier cover of the remote control.
•
The 40cm Pineware Mist Fan is now ready to use.
OPERATING THE MIST FAN
•
Remove the Water Tank from the Humidifier Power Base, turn it up-side down and you will
see a small plastic cover.
•
Open the cover by turning it in a counter-clockwise direction.
•
Fill the Water Tank with clean water.
•
Close the plastic cover by tightening it in a clockwise direction. Note that there is a white
silicone ring which must not be loosened when filling the Water Tank with water.
•
Place the Water Tank back onto the Humidifier Power Base.
•
Plug the Mist Fan into the main electrical supply. A
“
beep
”
sound will be heard indicating that
the Mist Fan is connected to the power.
•
The
“
POWER
”
indicator light on the Main Control Panel will illuminate.
•
Now the Mist Fan can be switched on either on its Main Control Panel or by the Remote
Control.
•
Press the ON button to switch the Mist Fan on.
•
By default, the Mist Fan will be switched ON in
•
Low Speed Setting,
•
Fixed Direction and
•
Normal Wind mode setting
•
After switching on the Mist Fan you can select different Speed Settings or the Wind Mode
that you prefer. The table below shows which switches perform which speed and wind
functions:
Remote
Control
Main
Control
Panel
Indicator Lights
Features
OFF
POWER
Standby mode. The fan is ready to
use but has not started operating yet.
ON/SPEED
LOW
MED
HIGH
Press Once -
Low Wind speed setting
Press Twice -
Medium Wind speed setting
Press Three Times -
High Wind speed setting
OSC
OSC
Press Once -
The Fan head will oscillate
When pressing again -
The Fan head will be fixed in one
direction only
MIST
MIST
Press Once -
The Fan will generate mist
When pressing again -
