Pin Genie PGD718, Руководство пользователя

Страница: 9 / 24

J
3
Make sure the cable is securely
fixed to the cable connector.
1 2
2.7
Install interior assembly
Unscrew the battery compartment
and then remove the cover.
Side hole
Center hole
Route cable through center hole, then push it into side hole.
I(2X)
H
I(2X)
H
Keep it in
upright position
Before screwing, check the vertical alignment
for the mounting plate and exterior
assembly.
After installation, use the back-up key to
test the latch. If the latch does not retract or
extend smoothly, adjust the screws to
ensure the latch system works smoothly.
5 4
Note: Do not install
batteries yet!
Connect the cable.
A
Make sure the thumbturn is in
its vertical position.
H1
H2
Please use the H1 screw for the
door with thickness of 35-43mm
whilst H2 screw for the door with
thickness of 43-50mm.
6