UPS PIco HV3.0A Firmware Code 040 Print Date 18.08.2017
Designed and Manufactured by PiModules and ModMyPi
www.pimodules.com www.modmypi.com
Setting up Procedure
What is in the BOX?
This package comes with everything you need to start using the
UPS PIco
HV3.0
HAT
right out
of the box. It is assembled, tested and contains all required accessories. A little work is
necessary to
setup the complete Raspberry® and
UPS PIco
HV3.0
HAT
in a single full operating
system, and this is instructed below.
Each Box contains the following parts:
•
1 x The
UPS PIco
HV3.0
HAT
module
•
1 x 40 THT Header (Stack or Top End)
•
1 x Dual layer wide temperature adhesive tape (used for battery mounting) stuck on
the bottom side of
UPS PIco
HV3.0
battery, or left free in the box
•
1 x Set of spacers (plastic spacers, rubber stick, or screws and plastic spacer tubes,
depending of production lot)
•
1 x Separate packed ultra-high current LiPO battery 450 mAh, 6A current
•
1 x Gold Reset Pin (POGO pin)
•
1 x Electromagnetic Sounder
•
2 x 8 pins Headers Strips
Please kindly notice that, due to shipping regulations, LiPO batteries are packed in the same
box but are physically or electrically separated and not connected to the
UPS PIco
HV3.0
module. It must be connected by the user, and it is a part of the installation procedure.
