Pilz PSEN op3.1, Руководство по эксплуатации, Страница: 7 / 10

PSEN op3.1/3.2
Operating Manual PSEN op3.1/3.2
1003607-EN-02
7
a
Reduce the sensitivity and determine the position in which the orange LED illumin-
ates and then goes out.
Attach transmitter
1. On the mounting surface, drill three M4 holes in the required position for the transmitter,
in accordance with the position of the through holes (see Dimensions).
2. Attach the transmitter to the mounting surface using three screws (M4, minimum length
25 mm).
Attach receiver
1. On the mounting surface, drill three M4 holes in the required position for the receiver, in
accordance with the position of the through holes (see Dimensions).
2. Attach the receiver to the mounting surface using three screws (M4, minimum length
25 mm).
Test
The test inputs on the transmitter enable a system test.
If the test inputs are activated and the light beam is not interrupted, the receiver must
switch.
a
Carry out the test and only put the muting sensors into operation if the test has been
successful.
Display and operator elements
[2] [3]
[1]