Pilz PSEN op2.1 L-, Руководство по эксплуатации

Страница: 9 / 18

PSEN op2.1 L­/ 2.2 T­Muting Set
Operating Manual PSEN op2.1 L­/ 2.2 T­Muting Set
1003535­EN­01
9
Procedure
Check the position of the mounting profile on the
safety light grid
and slide the mounting profile on
both units of the safety light grid along to the correct
position of the muting sensor. To do this, loosen the
hexagonal screws. Then tighten up the hexagonal
screws again.
The mounting profiles should be at the same height.
[1]
[2]
[1] Mounting profile for attaching the muting sensor
[2] Safety light grid on mounting surface
Fix the muting sensor with the small plates to the
mounting profile. [1]
[2]
[1]
[1] Hexagonal screws for attaching the mounting pro­
file to the safety light grid
[2] Allen screws for attaching the muting sensor to
the mounting profile
Wiring
Use one of the supplied connection cables to wire the muting sensors:
}
PSEN op cable M12 4­p. 0.75m L­muting for L­muting
}
PSEN op cableset for T­muting
a
Wire the muting sensors as shown in the following diagrams.