PSEN ma1.3-22 M12/8 VA
Operating Manual PSEN ma1.3-22 M12/8 VA
1004511-EN-02
16
}
Alignment errors of the guard must not adversely affect the safety function of the guard.
}
The assured operating distance S
ao
and the assured release distance S
ar
must be tested
under real conditions.
}
Do not apply any installation tools (e.g. Pliers) on the surfaces of the switch.
}
) is only achieved when Pilz con-
nection cables are used - these are available as an accessory - and when the con-
nector torque is complied with (see Technical details).
Application in series connections
}
Install the interface PSEN ix1 in the control cabinet and wire the interface with the eval-
).
Application in single connections
}
Install the control cabinet terminal PSEN ix0 F1 mag in the control cabinet and wire the
control cabinet terminal with the evaluation device (see
Wiring [
Installation of safety switch
Sensing face
Slide the switch through the hole in the
mounting surface with the sensing face to-
wards the actuator.
Attach the switch using 2 M12x1
hexagonal nuts.
The surfaces of the switch are not suitable
for applying an installation tool (e.g. pliers).
Also note the max. torque setting (see
).
