Pilot Communications 2011112/716/12, Руководство по эксплуатации и обслуживанию

Страница: 8 / 15

Valve – Gas Monitoring System Only
•
The solenoid valve should be connected down stream of the
regulator and as close to it as possible.
•
The base of the valve is marked “1” and “2” for gas in and gas
out, respectively, as shown below (Diagram 1).
Procedure
1. Open the unit by removing the side screws and separating the
two halves of the case.
2. Mount the back half of the case to a vertical surface using the
mounting holes.
3. Pass the two detector head cables and a suitable two-core
power supply cable through the routing holes. Draw sufficient
cable through the holes to enable connections to the PCB in
the front half of the case.
5
Diagram 1: Direction of gas flow