3
GeNeral INForMatIoN:
Before installation of your Pierce Stove these instructions should be read carefully to fully understand the controls of
your new stove. Keep these instructions for future reference.
Due care should be taken when unpacking and installing a Pierce Stove as not to cause damage to your new stove or its
surroundings. Check all components are present and functioning before installation occurs.
INstallatIoN reQuIreMeNts
Installation must always be completed in accordance with current building regulations by a competent qualified
person. Incorrectly installed stoves can cause serious accidents such as chimney fires or damage to insulation materials
in partition walls and or roofs and ceilings. The installation of the stove to current building regulations is the sole
responsibility of the home owner.
chIMNeY reQuIrMeNts
Do not install a Pierce Stove into a chimney that serves any other heating appliance. The chimney height must be a
minimum of 4.5 meters vertically from the floor on which the stove is installed to the top of the flue terminal in order
for the stove to perform satisfactorily. The chimney should not have an excessive cross sectional area and should be
in good condition without any cracks or blockages. The advice of an expert should be sought in relation to having
the chimney lined, if deemed necessary by an expert a suitable lining for a solid fuel stove must be used. The internal
diameter of any chimney or flue liner used must not be less than 125mm. Any flue liner and or adaptors used must be
fitted strictly to the manufacturer’s installation instructions. The flue should be checked and swept before connection
to the stove. There may be a need to fit a draught stabilizer if an excessive draft exists, advice should be sought from an
expert on the draft conditions. The chimney should be swept twice per year, any flue liner used should be cleaned in
accordance with manufacturer’s instructions.
aIr supplY / VeNtIlatIoN
When installing a stove it is recommended that a permanent air vent be fitted if not already in position. The vent should
have an effective area of 550mm2 per kW of rated output above 5kW. In some instillation conditions under 5kW output
stoves will have sufficient air for combustion from natural draughts from doors and windows. In newer properties
designed to be almost airtight it may be necessary to have a vent fitted for a stove under 5kW rated output. It is
recommended to seek expert advice on the air supply/ventilation for your installation to achieve the best performance
from your Pierce Stove. If an air vent is fitted it must not be obstructed for any reason when the stove is in use. An
extractor fan should not be fitted in the same room as your stove as fumes may emit into the room. It is recommended
to fit a Carbon Monoxide alarm for your safety where you have a stove Installed; this is not mandatory in the republic of
Ireland at present but is mandatory in the UK.
eXterNal surFace cleaNING
Cleaning on the matt finish stove is recommended with a brush attachment on a vacuum cleaner.
Cleaning on an Enamel finish stove is recommended with mild soapy water and a soft cloth.
Strong abrasive utensils or strong detergents should never be used, always clean the stove after cooling.