Picote Solutions Oy Ltd
34
www.picoteinstitute.com
STEP 2
Watch the CCTV screen for the resin flow. Note: it may be difficult to see the flow of
resin if the camera is turned upside
-
down. Watch closely and move the
camera and rotating shaft back and forth if necessary to check for resin flow.
STEP 3
Once resin can be seen flowing, stop the pump and turn the variable speed dial down
to the appropriate speed for the pipe diameter. Normally the Mini Miller is
between
950
—
1100
rpm (speed dial 2
-
3).
STEP 4
Start the coating from the far end. Pump out resin and brush it on. Pay close attention
to the flow of resin and lay a consistent bead of resin into the pipe. Also, watch the
bead of the resin around the edge of the brush. Pull slowly and evenly for 1m / 3ft.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
OPERATING THE COATING SYSTEM cont.
33
