6 Starting and Operating
22
Version: 1.1.1
MP116E
N-422 Linear Drive
NOTICE
Damage from pulling or moving out the rod!
Completely pulling or moving the rod out from the base body will destroy the N-
422.
Do
not
pull or move the rod out from the base body of the N-422.
Only put the N-422 into operation when it has been installed and completely
assembled in a positioning system with a limited travel range.
NOTICE
Increased friction due to lateral forces on the rod!
Lateral forces acting on the rod of the linear drive due to manual motion increase
the wear on the components of the drive.
Avoid moving the rod of the N-422 by hand.
NOTICE
Damage from collision of the N-422 with the hard stop!
When the hard stop of the positioning system has been reached or the drive is
blocked, but the N-422 is still being actuated, this can cause damage or
considerable wear to the N-422.
Do
not
place any objects in areas where they can get caught by moving parts.
Do
not
continue to actuate the N-422 at the end of the travel range.
INFORMATION
The drive electronics is adapted via parameters to the N-422. Changing parameter values can
cause undesirable results.
Only operate the N-422 when the parameters of the drive electronics have been correctly
set, see "Operating Parameters of the N-422" (p. 23).
For further information on the operating conditions, refer to the "Technical Data" section (p.
31).
The N-422 is started up with the E-870 (p. 36) drive electronics from PI.
6.2
Starting Up the N-422 with E-870 Drive Electronics
Requirements
You have read and understood the general notes on starting and operating (p. 21).
The N-422 has been installed properly (p. 13).
