8
Maintenance
NOTICE
Damage due to improper maintenance!
Improper maintenance can lead to misalignment and failure of the L-412.xx9232.
►
Loosen screws only according to the instructions in this manual or the instructions of our
customer service department (p. 25)
.
8.1
Maintenance Run
The maintenance run serves the purpose of distributing the existing lubricant.
The following intervals for the maintenance run depend on the operating conditions and the
period of use:
■
After 200 operating hours or at least after one 1 year
■
If the L-412.xx9232 is moved over a small travel range (<40 mm) during industrial
operation: After every 2000 motion cycles
Performing a Maintenance Run
1. Make sure that collisions between the L-412.xx9232, the load to be moved, and the
surroundings are not possible over the entire travel range of the L-412.xx9232. If
necessary, remove the load from the motion platform of the L-412.xx9232 for the
maintenance run.
2. Perform a maintenance run over the entire travel range:
a) Command the L-412.xx9232 to the end of a travel range and from there to the opposite
end of the travel range (see manual for the electronics).
b) If necessary: Command the L-412.xx9232 to a position, where the load can be mounted
onto the motion platform again and
mount the load back onto the L-412.xx9232 (p. 16)
.
8.2
Relubricating
The L-412.xx9232 is equipped with a grease nipple for relubricating the drive screw. For
continuous industrial use, the lubrication intervals and the lubrication quantity must be
determined individually.
Use Klüber STABURAGS NBU 12/300 KP only as lubrication for the L-412.xx9232.
If you have any questions on relubricating, contact our
customer service department (p. 25)
.
8.3
Cleaning
Requirements
✓
You have disconnected the L-412.xx9232 from the electronics.
Other Materials Required
■
Soft, lint-free cloth
■
Mild cleaning agent or disinfectant
If you have any questions on the auxiliary materials recommended for the L-412.xx9232,
contact our
customer service department (p. 25)
.
8 MAINTENANCE
L412M0006EN
‒
3/14/2019
21
M O T I O N | P O S I T I O N I N G
