Manual PIDM01
MA 1311-A001 EN
14
5 Installation
5.1 Mechanical Installation of the PIDM01 Module
Phytron always delivers the
phyMOTION
TM
completely assembled in order to make sure
you can start with the installation and the wiring right way.
Further Manual
Detailed information on this subject is in a supporting manual:
“
phyMOTION
TM
Modular Multi-
axis Controller for Stepper Motors”
The PIDM01 is delivered as a single module card if sent after service or repair or when an
expansion card was ordered.
In case you receive an individually packed PIDM01 as an expansion module or after repair
or service unpack the module in ESD protected area only.
CAUTION
– Possible damage!
The modules of the phyMOTION
TM
consist of sensitive electronic
components that can be destroyed by electrostatic discharge voltages.
- Always store and transport single modules in ESD protective
packaging.
- Always handle the components in compliance with the ESD
protection measures.
- No liability is accepted for any consequences resulting from
improper handling or non-ESD-friendly packaging.
Identify the correct slot position for the referring to your order and documentation. The
PIDM01 needs at least a POWM01 module and a MCM01 module on somewhere its left
side.
Before you install or replace modules, make sure that the phy
MOTION
TM
is unplugged.
