phytron phyMOTION INAM01.1, Перевод оригинального руководства

Страница: 17 / 45

phytron
17 MA 1275-A004 EN
5 Installation
Phytron always delivers the phyMOTION ™ completely assembled in order to make sure you
can start with the installation and the wiring right away.
Further manual
Detailed information on this subject is in a supporting manual:
“ phyMOTION
TM
Modular Multi-axis Controller for Stepper Motors”
5.1 Mechanical Installation
5.1.1 INAM01
In case you receive an individually packed INAM01 as an expansion module or after repair or
service unpack the module in ESD protected area only.
CAUTION – Possible damage by ESD!
T he modules of the phyMOTION
TM
consist of sensitive electronic components that
can be destroyed by electrostatic discharge voltages.
- Always store and transport single modules in ESD protective packaging.
- Always handle the components in compliance with the ESD protection
measures.
- No liability is accepted for any consequences resulting from improper
handling or non-ESD-friendly packaging.
i
CAUTION – Possible damage!
The INAM01 module is designed for a maximum supply voltage of 48 V
DC
. If it is
supplied with >48 V
DC
the card might be damaged.
- Make sure that a power module (POWM01, POWM02) is supplied on the left
with less than 48 V
DC
to avoid damage.
Before integrating or switching modules always make sure that the phyMOTION ™ is shut down
and the power supplies are disconnected.