Phytec nanoModul-164, Быстрый старт

Страница: 46 / 96

nanoMODUL-164 QuickStart Instructions
42 
PHYTEC Meßtechnik GmbH 2003 L-379e_4
2.3.3.2 “Blinky“
The “Blinky” example sends a program to the Flash that, when
executed, manipulates the single user SMD-LED D3 on the
Development Board which is mounted near the Boot (S2) switch.
This second example program provides a review of the FlashTools for
Windows download procedure:
•
Ensure that the target hardware is properly connected to the host-
PC and a power supply
•
Render the target hardware into Flash Programming Mode by
simultaneously pressing the Reset (S1) and Boot (S2) switches on
the Development Board and then releasing first the Reset (S1) and,
two to three seconds later, release the Boot (S2) switch
•
Start FlashTools for Windows
•
At the Serial Interface tab of the FlashTools for Windows
Worksheet, specify the proper serial port and transmission speed
for communication between host-PC and target hardware and click
the Load Flashtools button to transfer the modul based part of the
FlashTools for Windows to the target hardware.
•
Select the right protocol (default RS232) for further use of the
FlashTools for Windows.
•
Returning to the FlashTools for Windows Worksheet, choose the
Sectors Utilities tab, highlight Sector #0 in the Sectors Erase
section of the tab and click on the Erase Sector(s) button to erase
this memory sector
•
Wait until the status check in the lower left corner of the
FlashTools for Windows Worksheet finishes, returning the
connection properties description to the lower left corner of the
window
•
Next choose the File Download tab and click on the File Open
button
•
Type the complete pathway and name of the file you wish to
download C:\PHYBasic\nM164\Demos\Keil\Blinky\blinky.h86
directory (default location)