STEP1
STEP2
STEP3
Before physical installation, please ensure wireless settings are completed and
operational – to set wireless up, you need to connect the camera directly to your
router with an Ethernet cable.
If you plan to use Wi-Fi transmission, the Wi-Fi must be setup before the camera is
disconnected from the Ethernet cable of the local network. Minimum signal
strength of 3 bars is required for HD video transmission. Please ensure the
required signal strength is available at the point of installation, prior to installing
the camera.
Please note that the wireless signal travels easily through common building
materials such as wood, glass, sheet rock, and vinyl siding, but does not go
through metal.
Connect the power cord and Ethernet cable to the camera. Please refer to Figure 2.
Insert the RJ45 connector and DC plug connector into the rear cover of the
Weatherproof Junction Box. Ensure the power and network cables align with their
respective grooves at both sides of the sealing strip.
Please refer to Figure 2.
Attach the front cover; ensuring that the groove on the sealing strip presses tightly
against the cable. The bigger groove is for network cable and the smaller one is for
the power adapter cable (Please refer to Figure 2 and Figure 3).
Please make sure there is no gap between the front and rear cover sealing strips,
as this clean contact provides the waterproof seal.
9
