En
INSTRUCTION MANUAL
27
2. Group setting: Press Function Button 4 to access
. Press the
Function Button correspond to
to cycle through between Master (M)
and groups A,B,C. Power can be adjusted by the Selection Dial while a group is
selected (see note below)
3. Master with flash Mode ON/OFF: Press Function Button 4 to access
. Press the Selection Button correspond to
/
to cycle between master
flash on (
)or off(
).
Please Note:
- Group setting is only available in Manual Mode
- Master flash on: The Master flash on the camera will fire when a photo is
taken.
- Master flash off: The Master flash on the camera will not fire when a photo
is taken. --The flash will emit a short burst of light to communicate with slave
flashes but this light will not be part of the exposure.
OP Rx (Slave) Mode:
1. Channel setting: Press Function Button 4 to access
. Press the
Function Button correspond to
to enter channels adjustment area.
Use the Selection Dial to change the channels between Ch1-4.
2. Group setting: Press Function Button 4 to access
. Press the Function
Button correspond to
to enter group selection area. Use the Selection
Dial to select between group A,B,C. Press the OK Button to confirm.
Please note:
- Make sure the OP Tx (Master) and OP Rx (Slave) flashes are set to the same
transmission channel (1-4).
- Do not place any obstacles between the master unit and slave unit(s).
Obstacles can block signal transmissions.
- When using wireless bounce flash, please ensure the slave flash Wireless
Signal Receiver Area faces toward the Master flash.
- When using only one on-camera flash set Wireless Mode to “Off”.
Using OP Tx/Rx Wireless Triggering
With a flash in OP Tx (Master) Mode on the camera and remote flashes in OP Rx
Slave Mode, pressing the shutter Button will fire the OP Tx (Master) flash (if set
to fire the flash) and flashes set to OP Rx (Slave) Mode within the range of the
OP Tx (Master) flash. The camera and flash will meter the scene and fire flashes
in TTL Mode to properly expose the scene.
