En
INSTRUCTION MANUAL
21
OdinII Tx Mode interface
Using OdinII Tx Mode
After selecting OdinII Tx Mode (above)
1. Press Function Button 4 until the LCD displays
.
2. press Function Button 3 (underneath
) to cycle through M (Master
flash), A,B,C.
3. Pressing the Mode Button while a Group is selected will change the Mode
from TTL, M (Manual) and Off.
4. Use the Selection Dial when a group is selected to adjust the EV Level ±3EV
in 1/3 stop in TTL Mode, or the power level (1/128 to 1/1 in 1/3 stops) in Manual
Mode.
4. Press the OK Button to confirm and exit the Odin II Tx Mode editing menu.
Setting in Odin TX wireless mode
The Auto Metering Mode can be used similarly to a light meter to measure and
set the flash power needed for proper exposure
To use auto metering:
1. Set the respective groups to Manual Mode (M), the groups can be set to
any power level
2. Press and hold the option/confirm button until the LCD displays Auto
Metering.
3. Take a test shot
4. The suggested power level will be displayed on the Odin II in the respective
groups.
Please Note:
· To Cancel Auto Metering: press the flash group button and the option/
confirm button to exit auto metering mode for that group.
· Press the test button to exit auto metering mode for all groups.
