Phottix Juno Li60, Руководство пользователя

Страница: 7 / 44

7
Status LED
Flash-ready indicator. In Quick Flash Mode, the LED will turn
green when the flash has the minimum recycle charge. It will
turn red when fully charged.
Overheating Protection
The Phottix Juno Li60 contains an overheating protection circuit
that will slow flash recycle time to avoid overheating-related
damage. Approximately 30 full-power flashes in a short amount
of time will trigger this protection. Stop using the flash and wait
10 minutes for it to cool down.
Sync and USB Ports
1. The 3.5mm Port can be used with a 3.5mm mono cable to
trigger the flash – from a flash trigger or camera. This port is
input only – flash signals are not output from this port.
2. The Micro USB port is used for repair center only.
Attaching the Flash to the camera
1. Turn off both the camera and flash
2. Align the flash hot shoe with the camera hot shoe.
3. Slide the flash into the camera hot shoe until fully inserted.
4. Lock the flash in position by pushing the locking lever to the
right until the lock engages with a click.
5. To Unlock, press the locking release Button on the locking
lever and slide to the left.
Turning the Flash On/ Off
1. To power on the flash move the power switch to the on
position.
2. To power off the flash move the power switch to the off position.
3. To Lock the flash: Move the power switch to the“LOCK”positios.
This “locks” the Buttons and Dial of the flash, so setting cannot
be accidentally changed.