Photron IDP-Express R2000, Руководство по оборудованию

Страница: 25 / 53

14
Chapter. 2 Setup
◇
In case of the Pencil Type Head
1. It checks that the camera controller is turned off.
2. A camera cable is connected to the camera controller side.
* The connection method is the same as a cube type head.
3. The cable from a camera controller and the cable which has come out of the camera head
are connected.
Each connector part is checked, as shown in the following figure a red point is united and it
connects. If it inserts normally, there is a feeling of a click.
■Camera Controller Side ■Camera Head SIde
4. When you remove camera cable, it is possible to remove to pull to outside.
It draws out in the direction of an arrow.
Press down the place of a red point.
Always secure the camera cable by tightening the screws attached to the camera cable's
connector.
If the camera cable is pulled out while the power is on, it can cause a malfunction.
Always turn the Camera Controller's power off when attaching or removing Camera Heads.
Adding or removing Camera Heads with the power on can cause a malfunction.