FASTCAM SA-X2
25
1.2 Part Names
1.2.8
GigabitEthernet Connector
It is an Ethernet connector for communicating with the PC and is a common RJ45 connector.
Connect a 1000BASE-T compatible interface board and this product with a LAN cable. For the LAN
cable, prepare a UTP or STP Cat 5e (enhanced category 5) or higher LAN cable. (UTP: Unshielded
Twisted Pair, STP: Shielded Twisted Pair)
The system has two sets of Gigabit Ethernet interface connectors incorporated. Using these two
connectors simultaneously will make much faster download of image data possible.
1.2.9
SD Memory Card Slots
These slots are for an SD Memory Card to save image data. Insert an SD Memory Card which is on
the market.
Recorded image data can be saved on an SD card and the saved data can be played and converted
to other formats by "PFV".
The system's factory default IP address is below:
IP ADDRESS: GIGABIT ETHER 1
192.168.0.10
GIGABIT ETHER 2
192.168.1.10
NETMASK:
GIGABIT ETHER 1
255.255.255.0
GIGABIT ETHER 2
255.255.255.0
GATEWAY ADDRESS: 0.0.0.0
PORT: 2000 (Fixed, not changeable)
Photron recommends using an STP cable over long distances or in noisy locations.
Refer to “SD Memory Card Userʼs Manual” for the details of operation.
If a SD Memory Cardʼs performance is not enough the required specifications, there is possibility that
the writing speed will become slow and/or there will be an error. Refer to “SD Memory Card Userʼs
Manual” for the required specifications.
Содержание FASTCAM SA-X2
