PHOTONIS PD-PRO-16B, Руководство пользователя

Страница: 15 / 25

Chapter 2
Operation
8. General
This chapter provides operating instructions for the PD-PRO-16B.
CAUTION
The PD-PRO-16B is a precision electro-optical device - handle it with care!
9. Safety
An internal component within the image intensifier tube contains toxic materials. During normal
operation, the operator will never come into contact with this component. However, if the tube is
damaged or broken, avoid inhalation or ingestion of the phosphor screen materials, and avoid contact
with open wounds.
a. If the toxic material comes into contact with your skin, wash the affected area with
soap and water. If any material is swallowed, drink large quantities of water, induce
vomiting and seek medical assistance as soon as possible.
b. The objective protective cover must be fitted at all times when the night vision goggle is
not in use. Damage to the image intensifier can occur if it is pointed to a strong
light source such as daylight for extended periods, even when power is switched off.
c. Never point the night vision goggle towards the sun, even when shut off and with an
objective cover with pinhole. The center of the photocathode can be damaged. When
training at daylight a totally shuttered objective cover or a neutral density filter must be
used. A searchlight, a camera flash or any brightly reflecting object, at distances of
more than 5 meter will not damage auto-gated tubes. Never point a visible or IR laser
towards eyepiece or objective as the tube will be damaged permanently.
d. Always remove the battery after using and before repackaging, to avoid acid leakage due
to defective battery and permanent damage to the electronic board of NVLS EVO.
e. Rinse thoroughly in tap water after immersion in sea water to prevent drying of salt deposits.
f. Dry the night vision goggle completely before replacing it in the tactical bag or hard-shell case.
g. Take care when using the V and IR positions of the operation switch. In V position bright
light is shining out of the eyepiece, if not covered. In IR position IR light is beaming
around, which can easily be detected by enemy forces and bright light is shining out of
the eyepiece, if not covered.
10. Battery Installation
CAUTION
The PD-PRO-16B is powered by a single 1.5V "AA" size alkaline or lithium battery. Do not use any other
type of battery. Batteries with a higher voltage will damage the
MINIMUS-BINO.
a. Turn the battery cap counterclockwise to remove it from the battery compartment.
b. Make sure the battery compartment is clean and dry.
c. Make a note of the polarity indicated on the side of the PD-PRO-16B and install a battery.
d. Put the battery cap in position at the battery compartment.
e. Turn the battery cap clockwise until the battery cap is tightly closed and gives a good seal against
the “O”-ring.
p. 15