Phoenix 2700 DH
July 2018
4
•
Contact an electrician should the power cord provided with the laminator not match the
receptacles at your location.
•
Ensure that the voltages of the power supply you are using match the rated working
voltages before operations. Do not use incorrect power supply.
•
Do not use damaged wires or sockets. If abnormal conditions occur, switch off the
power supply first.
•
Only a licensed electrician should install wiring and outlet for the laminator.
•
Do not defeat, disable, or remove electrical and mechanical safety equipment such as
interlocks, shields and guards.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's cTUVus safety certification.
