Phoenix 2700 DH
July 2018
21
22. Troubleshooting
Problems
Causes
Solutions
Machine does not turn on
1.
No power supply
2.
Main power switch is OFF
3.
Blown motor fuse
4.
Motor has failed
5.
Machine is in Sleep mode
1.
Plug in power cord
2.
Move power switch to ON positon
3.
Replace fuse on rear panel
4.
Change the electric motor
5.
Rotate Reset switch on rear panel
Heaters do not come on
1.
Heat switch not on
2.
Safety shield or Feed Table not in
place with safety interlock
1.
Move heat switch to ON position
2.
Insure safety latches are in place
Ready light does not come on
1.
Rollers not hot enough
2.
Heaters are not turned on
1.
Warm up time is 20-25 minutes
2.
Move heat switch to ON position
Poor film adhesion/cloudy prints
1.
Nip roller pressure to low
2.
Operating too fast
1.
Place gap handle in down position
2.
Turn speed dial to slower speed
Bubbles in film around print
1.
Operating too slow
1.
Turn speed dial to faster speed
Film supply roll gets loose during
operation
1. Not enough brake tension supply
1. Increase brake tension on supply roll
Lamination output is curled
1.
Sheet is curled upward
2.
Sheet is curled downward
1.
Reduce top roll tension
2.
Reduce bottom roll tension
Two audible beeps when machine
is turned ON, machine will not heat
up
A Safety interlock switch is not in
position
Check both Safety Shield and Feed Table
interlocks (See sections 11 and 12)
Power light flashing and 3 audible
beeps
Heat sensor is blocked
Clear sensor then turn motor off then Main
power off then on (See section 17)
Ready light flashing
Machine is in Standby Mode
Turn motor to FWD then off, allow machine
to heat up (See section 15)
Power is ON but not lights
Machine is in Sleep Mode
Turn power switch OFF then ON, allow
machine to heat up (See section 15)
Main power switch if OFF and
motor is in FWD positon
Machine was turned OFF while motor
was running
Turn power to ON and motor to OFF then
ON (See section 16)
Power and ready lights are both
flashing
Machine is in Clean mode
Turn Power to ON and motor to OFF then
ON
